Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
4KW SHD RADAR SOFTWARE UPDATE ISSUE
06-15-16, 10:59 AM
Post: #1
4KW SHD RADAR SOFTWARE UPDATE ISSUE
Hi Tech,

I have just updated my E125 to v17. However, my radar will not update; it has v.08 & the download (via WiFi) lists v2.25 as available. All other connected network devices updated successfully. The download page indicates upgrade failed & to power-up radar (which was powered-up during the install). Strangely, after this, the master MFD radar window shows radar ID as 08001 while the slave MFD shows ID 20136. At that point I am not able to power-up the radar unless I cycle power to the VCM100, then I'm able to go to the slave unit radar menu & change the radar from 20136 to 08001 & at that point all function fine, just that I cannot do the update.

VCM100 LED indicators:
On - Green Solid
Fault - Off
Sleep - Off

Thanks,
John
Find all posts by this user
Quote this message in a reply
06-15-16, 04:33 PM (This post was last modified: 06-16-16 08:29 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: 4KW SHD RADAR SOFTWARE UPDATE ISSUE
Forum:
Tech has advised that this is normal: When v17 is downloaded the upgrade for 4kw SHD radars should not be installed if your radar is Model E52081E—that is, it begins & ends with an “E”. The current software for this model is v.08.
Tech: Please correct this if I have misstated anything here.
Regards,
John
Find all posts by this user
Quote this message in a reply
06-16-16, 08:30 AM
Post: #3
RE: 4KW SHD RADAR SOFTWARE UPDATE ISSUE
John,

Thanks for sharing this with the Forum. The information within your last post appears correct.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)