+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [DG] [DG11] E120 problem getting past Limitation on Use page (/showthread.php?tid=9844)
[DG11] E120 problem getting past Limitation on Use page - seeray96 - 11-04-19 10:35 AM
I sent my original request for assistance last week, but have not rec'd a response.
To repeat, on boot-up I can't get past the Limitations on Use page. I'm using software ver 5.69.
RE: [DG11] E120 problem getting past Limitation on Use page - Derek - Raymarine - Moderator - 11-06-19 10:14 AM
Hi Seeray96
Thank you for your enquiry
This suggests that you have an MFD referred to as an E classic. The most probable solution is to carry out a factory reset, this is done as follows . . .
* With the unit turned off press and hold the left hand soft key
* Keep it pressed and turn the unit on
* On screen it will say 'Factory Reset' and count down from 3
* Unit will reset and load into normal operation. This can take a couple of extra minutes than normal.
**Please make sure you back up all Waypoints and Routes etc to a separate Compact Flash Card other than your Cartography Card**
Regards
Derek