Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG11] E120 problem getting past Limitation on Use page
11-04-19, 10:35 AM (This post was last modified: 11-06-19 10:08 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] E120 problem getting past Limitation on Use page
I sent my original request for assistance last week, but have not rec'd a response.
To repeat, on boot-up I can't get past the Limitations on Use page. I'm using software ver 5.69.
Find all posts by this user
Quote this message in a reply
11-06-19, 10:14 AM
Post: #2
RE: [DG11] E120 problem getting past Limitation on Use page
Hi Seeray96

Thank you for your enquiry

This suggests that you have an MFD referred to as an E classic. The most probable solution is to carry out a factory reset, this is done as follows . . .

* With the unit turned off press and hold the left hand soft key
* Keep it pressed and turn the unit on
* On screen it will say 'Factory Reset' and count down from 3
* Unit will reset and load into normal operation. This can take a couple of extra minutes than normal.

**Please make sure you back up all Waypoints and Routes etc to a separate Compact Flash Card other than your Cartography Card**

Regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)