[CA] [CA11] No AIS - Printable Version +- Raymarine forum (http://forum.raymarine.com) +-- Forum: Raymarine Forums (/forumdisplay.php?fid=1) +--- Forum: AIS (/forumdisplay.php?fid=22) +--- Thread: [CA] [CA11] No AIS (/showthread.php?tid=9959) |
[CA11] No AIS - [email protected] - 11-20-19 09:56 AM My e127 has stopped seeing my AIS and I get a "No AIS" message at the bottom of the display. The AIS 650 is sending a signal to my lap top via the usb cable and I am seeing targets on my lap top using Coastal Explorer software. I have re set the MFD and still no AIS. I have also tried a new interface cable between the AIS 650 and the backbone. Any thoughts would be appreciated. RE: [CA11] No AIS - Chuck - Raymarine - Moderator - 11-20-19 01:23 PM Welcome to the Raymarine Forum captedl99, Please click here to view a FAQ addressing this subject. The AIS650 should not be simultaneously powered be the vessel and connected via USB to a PC which is in turn being powered by an AC/DC power supply. Failure to heed this recommendation may result in a ground loop which may result in communications issues and/or damage to the AIS650 and/or PC. Should the MFD's diagnostics feature detect other devices with have been interfaced to the system's powered and properly terminated SeaTalkng/NMEA 2000 backbone, then it would appear that the AIS650's SeaTalkng/NMEA 2000 communications interface has suffered a failure, necessitating that it be sent to Raymarine’s Product Repair Center to be bench checked / serviced. Alternatively, you may want to consider disconnecting the AIS650 from the SeaTalkng/NMEA 2000 backbone and instead interface the 38400 BAUD leads NMEA 0183 of the AIS650 to the NMEA 0183 Port 1 leads of the e127 MFD's Power/NMEA 0183/Video Input Cable. |