Raymarine forum / Raymarine Forums / Multifunction Displays v / e Series Data Source Selection using E22158 Seatalk Converter

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
e Series Data Source Selection using E22158 Seatalk Converter
03-01-16, 03:33 PM
Post: #1
Bill Kneller Offline
Junior Member
**
 		Posts: 17
Joined: Feb 2016
Reputation: 0
e Series Data Source Selection using E22158 Seatalk Converter
This post is a continuation of the post I started on the old forum at this link where I reported that the e97 and e125 MFD operating with Lighthouse V15 software would not allow manual selection of a data source on the Seatalk NG/ NMEA 2000 bus.

It turns out that the converter needed a software update to version 2.01. I was unable to get the MFD to recognize that the converter needed a software update and was unable to manually push it. I returned the converter to Raymarine and it was updated to the latest V2.01 software at no charge.

I am happy to report that this fixed the MDS problem and can now select the electronic compass I desire to use, rather than the compass on the S1G autopilot. Here is my system interconnection diagram for those interested. The system successfully integrates Raymarine, Nexus, Garmin, B&G and Standard Horizon products.
Bill Kneller
Vento Solare, J/109 #266
Find all posts by this user
Quote this message in a reply
03-01-16, 04:05 PM (This post was last modified: 03-01-16 04:05 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: e Series Data Source Selection using E22158 Seatalk Converter
Welcome to the new Raymarine Forum Bill,

Thanks for the follow-up report.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication