Raymarine forum / Raymarine Forums / Instruments v / Speed issue w ST60+

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Speed issue w ST60+
09-29-17, 03:30 PM
Post: #1
Bodon68 Offline
Junior Member
**
 		Posts: 2
Joined: Sep 2017
Reputation: 0
Speed issue w ST60+
On my ST60 Graphics display when I get to the speed mode, all I see is "Race Time --:--". No SOG or other info....any suggestions on where to start?
Find all posts by this user
Quote this message in a reply
09-29-17, 03:45 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Speed issue w ST60+
Welcome to the Raymarine Forum Bodon68,

Should a ST60/ST60+Graphic Instrument not sense that it has been interfaced to a source speed (through water) data, then its Speed chapter will only permit the Race Time page to be displayed. Accordingly, it would be recommended that troubleshooting start with verifying that the ST60/ST60+Graphic Instrument is repeating data from other devices on the SeaTalk bus. If so, then it is possible there is a fault with the speed instrument's communications circuitry or its network connection to the SeaTalk bus.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication