Raymarine forum / Raymarine Forums / Multifunction Displays v / c/e-Series MFD's keypad is not firmly attached to my new MFD

Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
c/e-Series MFD's keypad is not firmly attached to my new MFD
06-09-16, 10:49 AM (This post was last modified: 01-11-17 01:56 PM by Chuck - Raymarine - Moderator.)
Post: #1
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
c/e-Series MFD's keypad is not firmly attached to my new MFD
c/e-Series MFD's keypad is not firmly attached to my new MFD

The key mat of the c/e-Series MFDs is designed to float freely above the MFD's keyboard PCB. The left side of key mat is designed to be held in place by tabs on the key mat which slide under a lip on the right most side of the screen. The top and right sides of the key mat are designed to be held in place by the MFD's trim ring.

RAYFAQ#
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication