Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
sonar dont read while running
08-10-17, 03:42 PM (This post was last modified: 08-17-17 09:21 AM by Chuck - Raymarine - Moderator.)
Post: #1
sonar dont read while running
just put in axiom 9, so far not happy. navionics sd card was blank they are sending new one. second it reads fine while drifting but the unit don't read while running. any suggestions?

thanks,
capt jimbo
Find all posts by this user
Quote this message in a reply
08-17-17, 10:01 AM
Post: #2
RE: sonar dont read while running
Welcome to the Raymarine Forum Jimbo,

I'm a bit confused about whether you are reporting a problem with the MFD's Sonar application or with the MFD's Chart application. If you are reporting a problem with the MFD's Sonar application loosing bottom contact when underway, then please click here to view a FAQ addressing this subject. Please a click here to view a another FAQ addressing this subject.

Should the MFD's Chart application cease displaying detailed cartography when in use, then it would be recommended that your verify that the chart card has been fully seated within the MFD's memory card reader and that the rubber seal has been pressed back in place over the MFD's memory card reader. Should the problem persist, then it would be recommended that the Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)