Raymarine forum / Raymarine Forums / Instruments v / Can a MFD calibrate instrument transducers interfaced to an iTC-5 or ST70/ST290 pods?

Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can a MFD calibrate instrument transducers interfaced to an iTC-5 or ST70/ST290 pods?
02-09-18, 09:37 AM (This post was last modified: 02-09-18 09:38 AM by Chuck - Raymarine - Moderator.)
Post: #1
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
Video Can a MFD calibrate instrument transducers interfaced to an iTC-5 or ST70/ST290 pods?
Can a MFD calibrate instrument transducers interfaced to an iTC-5 or ST70/ST290 pods?

MFDs are exclusively capable of calibrating, configuring offsets, configuring alarms associated with the data produced by fishfinder transducers (which may additionally have temperature and/or speed sensing capability) which have been interfaced to the transducer socket of a MFD or fishfinder sonar module. Instrument transducers which have been interfaced to an iTC-5 or ST70/ST290 pod cannot be calibrated by MFDs. An i70S MFID, i70 MFID (retired), or ST70 MFID (retired) must be installed within the system to permit the data associated with the transducer to be visible to the rest of the system, to be calibrated, and to configure any alarms or offsets associated with the data produced by the transducer.


RAYFAQ#
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication