[DG] [DG11] Power issues with my Dragonfly 7
|
05-12-20, 02:12 PM
(This post was last modified: 05-14-20 09:03 AM by Derek - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[DG11] Power issues with my Dragonfly 7
Having trouble with my Raymarine Dragon Fly 7 graph on my 16ft boat. I have it wired with an inline fuse with heavy wire directly to the starter battery that has the 40hp motor, bilge, and lights running on it. Problem is, every time I throttle up or down I lose power to the graph. It turns back on when the motor is off or idle.
I don’t have room for another big battery but would like to know if there is a more powerful starter battery anyone can suggest that would solve the issue. I found some small batteries that could fit that are suggested for kayaks but would like to avoid another battery if possible. Any suggestions or ideas that would fix the problem? |
|||
05-14-20, 09:06 AM
Post: #2
|
|||
|
|||
RE: [DG11] Power issues with my Dragonfly 7
Hi Thegolfpro313
Thank you for your enquiry, The most likely issue is not lack of voltage but too much! The Dragonfly is protected against overvoltage and I suspect when the engine is revv'd the output voltage from the engine alternator is much higher than the range accepted by the Dragonfly, or possible is very spikey from a voltage point of view and the Dragonfly is shutting down to protect itself. Try fitting a power supply conditioner in the power lead to the dragonfly to smooth the voltage and prevent the voltage becoming too high for the unit to handle. Regards Derek |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)