Raymarine forum / Raymarine Forums / Autopilots v / Ev 200 Hynautic installation update

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ev 200 Hynautic installation update
08-28-16, 07:52 PM
Post: #1
mr 88 Offline
Junior Member
**
 		Posts: 5
Joined: Jul 2016
Reputation: 0
Ev 200 Hynautic installation update
Upon further review I have the two line pressurized system. This diagram is on page 15 figure 7 in your hydraulic pump installation guide.I will set it up the way the diagram shows it instead of trying to T it immediately as it comes out of the reservoir. Was a little confusing as I have three lines and it is called a 2 line system.
Find all posts by this user
Quote this message in a reply
08-29-16, 03:07 PM (This post was last modified: 08-29-16 03:08 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Ev 200 Hynautic installation update
Welcome to the Raymarine Forum mr 88,

Your comments have been noted. For the benefit of others seeking to understand the hydraulic pump installation, the diagram is shown below:

[Image: attachment.php?aid=560]


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication