Raymarine forum / Raymarine Forums / Multifunction Displays v / MFD shield wire connection

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MFD shield wire connection
03-23-16, 06:58 PM
Post: #1
[email protected] Offline
Junior Member
**
 		Posts: 2
Joined: Feb 2016
Reputation: 0
MFD shield wire connection
I am completely revamping my sailboat from Patherfinder/ST gear to eS97, a125, STng, etc. The power/data cables for the MFDs have shield wires, which the manual says to hook to the RF ground or -12v. My RF ground is isolated from -12v to eliminate DC loops. What is the internal connection of the shield? simple VOM measurements suggest that they are capacitively coupled.
Craig
S/V Sequoia
Find all posts by this user
Quote this message in a reply
03-24-16, 09:03 AM (This post was last modified: 03-25-16 07:45 AM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: MFD shield wire connection
Welcome to the Raymarine Forum Craig,

Please click here to view a FAQ addressing this subject. When installed in the manner specified within the referenced FAQ, the Raymarine electronics will not result in a ground loop.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication