[CA] [CA11] All routes showing up on charts

[nharrison5]

Previous to updating LH 3 to the latest version (v3.10.71) on my eS127, only the active route would show up on the Navionics chart. After the update, all routes show up, whether active or not.

Since I have multiple overlapping routes on a narrow river system, whenever I pan out to ensure that I am in the main channel, the map is now obscured by the waypoint icons for the routes. Please see the attached example. The route at the top right is the one I have active. The ones in the lower left are the inactive ones.

Is there a way to “turn off” all routes except for the active ones?

[Chuck - Raymarine - Moderator]

Welcome back to the Raymarine Forum Nate,

By default, all routes and waypoints which are imported from a GPX file into the MFD's memory will be shown by default. After importing routes and/or waypoints, one may hide all routes within the Chart application page/pane being viewed by using the command sequence MENU->WAYPOINTS, ROUTES, TRACKS->SHOW/HIDE->HIDE ALL. Waypoints may be similarly hidden. These routes or waypoints may later be shown in a manner similar to that used to hide the routes and waypoints. After doing so and when then seeking to navigate a route, the Chart application will be commanded to follow a route from the route list stored within the MFD's memory. This action will also cause the corresponding route and its waypoints to be be displayed.

A feature request will be logged to consider defaulting the Show/Hide attribute for each route or waypoint to be set to HIDE when a route or waypoint is imported.

Please click here more information concerning Feature suggestions.

[nharrison5]

Thank you, Chuck. I will hide the routes when I get back up to the boat.

[Chuck - Raymarine - Moderator]

You're welcome