Raymarine forum / Raymarine Forums / Marine Cameras v / CAM200 IP loses picture

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CAM200 IP loses picture
05-23-20, 06:02 PM
Post: #1
ocgrant Offline
Junior Member
**
 		Posts: 14
Joined: Jul 2019
Reputation: 0
CAM200 IP loses picture
I have a CAM200 and a CAM220 both powered from the same source and the CAM200 (engine room camera) stops displaying on the MFD after about 20 minutes "video signal lost" pops up. If I cycle the power to just that camera it comes back. Why is this happening and how do I fix? The CAM220 works perfectly.
Find all posts by this user
Quote this message in a reply
05-28-20, 01:13 PM
Post: #2
Chris - Raymarine - Moderator Offline
Senior Member
****
 		Posts: 266
Joined: May 2016
Reputation: 0
RE: CAM200 IP loses picture
Hello ocgrant,

I would recommend checking the cables and connections to the CAM200. If the issue persists I would recommend sending the unit into our service department to get evaluated.

Chris,
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication