Raymarine forum / Raymarine Forums / General Discussions v / AIS650 Network Install

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
AIS650 Network Install
10-16-17, 09:14 PM
Post: #1
moonzy1 Offline
Junior Member
**
 		Posts: 14
Joined: Oct 2017
Reputation: 0
AIS650 Network Install
Adding AIS 650 to new Axiom Network.

All other components tied into switch.

AIS networked via N2K: Can it go straight across 2 MFD's via the MFD spur cables to a backbone w T connector?

Or does it have to go to a STng Hub and network in with the MFDs at that point?
Find all posts by this user
Quote this message in a reply
10-17-17, 12:38 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: AIS650 Network Install
Welcome to the Raymarine Forum moonzy1,

Should the MFD's be interfaced to one another via an Ethernet network switch, then the Data Master MFD and AIS650 will each be interfaced as an individual spur to a powered and properly terminated SeaTalkng / NMEA 2000 backbone. The Data Master MFD will in turn transmit the AIS data received to the non-Data Master MFDs via the Ethernet communications network.
Find all posts by this user
Quote this message in a reply
10-17-17, 01:42 PM (This post was last modified: 10-17-17 01:50 PM by Chuck - Raymarine - Moderator.)
Post: #3
moonzy1 Offline
Junior Member
**
 		Posts: 14
Joined: Oct 2017
Reputation: 0
RE: AIS650 Network Install
I understand
Thank you
Find all posts by this user
Quote this message in a reply
10-17-17, 01:50 PM
Post: #4
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: AIS650 Network Install
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication