Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] i70s System Pack
04-13-18, 10:10 AM (This post was last modified: 04-13-18 01:11 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] i70s System Pack
I have ordered a i70s system pack and 2 supplementary i70s. Unfortunately, I have not received it yet, and my boat goes into the water this weekend for the summer season.
The i70s shall replace an Autohelm ST50 speed, ST50 depth and ST50 Wind.
1. Can I connect the wind vane from the ST50 to the iTC5, otherwise I must wait to set the mast?
2. Can I connect the speed sensor and the depth sensor from the ST50 instruments to the iTC5?


Rg
Find all posts by this user
Quote this message in a reply
04-13-18, 01:15 PM
Post: #2
RE: [CA] i70s System Pack
Welcome to the Raymarine Forum Rg,

Q1. Can I connect the wind vane from the ST50 to the iTC5, otherwise I must wait to set the mast?
A1. Negative. The wind vanes supported by the ST50 instruments are not compatible with the iTC-5. The currently installed wind vane must be replaced with the E22078 (0m cable) | E22079 (50 cable) Wind Vane.

Q2. Can I connect the speed sensor and the depth sensor from the ST50 instruments to the iTC5?
A2. Yes.
Find all posts by this user
Quote this message in a reply
04-13-18, 02:05 PM (This post was last modified: 04-13-18 02:32 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA] i70s System Pack
Thanks:-)
Find all posts by this user
Quote this message in a reply
04-13-18, 02:32 PM
Post: #4
RE: [CA] i70s System Pack
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)