Raymarine forum / Raymarine Forums / Fishfinders v / [CA] Rv-220 installation

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Rv-220 installation
05-12-18, 01:25 PM (This post was last modified: 05-14-18 03:03 PM by Chuck - Raymarine - Moderator.)
Post: #1
Kccatfish1 Offline
Junior Member
**
 		Posts: 2
Joined: Mar 2018
Reputation: 0
[CA] Rv-220 installation
Is there a maximum ditance of separation when installing a pair of RV 220? The easiest place to put them so as to not interfere with my boat trailer would be about 6 feet apart. My boat is actually 9 feet wide. If I put them 6 feet apart, will there be a gap in what they can read? I could put them closer together, however I would need to modify my trailer.
Find all posts by this user
Quote this message in a reply
05-14-18, 03:41 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] Rv-220 installation
Welcome to the Raymarine Forum Kccatfish1,

RV Thru-Hull Transducer Pair have been designed and tested for a maximum separation of 4'. Should this distance be exceeded, then it may well cause a blind spot directly beneath the keel.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication