Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Axiom provide wind offset functionality ?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom provide wind offset functionality ?
06-29-18, 09:24 PM (This post was last modified: 07-02-18 10:08 AM by Chuck - Raymarine - Moderator.)
Post: #1
nurber Offline
Junior Member
**
 		Posts: 8
Joined: Apr 2016
Reputation: 0
[CA11] Axiom provide wind offset functionality ?
Hi Forum. This boat is using x2 Axiom 7 MFDs with no instruments. Is there wind offset functionality in Axioms ? The wind transducer is ultrasonic Maretron unit ( WSO100 ). Maretron provides offset, but it requires, according to Maretron, their USB100 gateway product to program ( I have Actisense ). Any other ways, perhaps temporarily with an i60 or i70, to program offset in this system ?
Find all posts by this user
Quote this message in a reply
07-02-18, 10:11 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Axiom provide wind offset functionality ?
Welcome to the Raymarine Forum nurber,

Per the FAQ found here, should a third party NMEA 2000 sensor require calibration, offsets, etc., then it will be necessary to calibrate the sensor per the third party sensor manufacturer's instructions. Calibration of third party sensors may require third party hardware and or computer software.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication