Raymarine forum / Raymarine Forums / Multifunction Displays v / Problems with Axiom 12

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problems with Axiom 12
06-30-17, 06:03 PM
Post: #1
Jazevedo Offline
João Azevedo
**
 		Posts: 20
Joined: Mar 2016
Reputation: 0
Problems with Axiom 12
Dear Members,

After install Axiom 12 and put the Navionics plus card, something wrong happens in the screen and the MFD is not Running. Please see the photo attached. How can I solve this problem?

Best

João Azevedo
Find all posts by this user
Quote this message in a reply
07-05-17, 10:28 AM (This post was last modified: 07-05-17 10:29 AM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Problems with Axiom 12
Welcome to the Raymarine Forum João,

It is recommended that the Axiom MFD be updated with the latest available Raymarine product software update and that a System Settings & Data Reset be commanded (should you be able to interact with the MFD's user interface). Should the problem persist thereafter, then it is recommended that the MFD be tested with another Navionics+ chart card. Should the problem abate, then it would be recommended that Navionics (508-291-6000) be contacted to replace the chart card. Should the problem persist, then it would be recommended that the MFD be replaced by the dealer (if purchased within the last 30 days) or sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication