Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] Axiom RMK-10

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom RMK-10
04-24-18, 11:04 PM (This post was last modified: 04-27-18 08:46 AM by Chuck - Raymarine - Moderator.)
Post: #1
Larrysr Offline
Junior Member
**
 		Posts: 10
Joined: Aug 2017
Reputation: 0
[CA] Axiom RMK-10
RMK-10 connected to HS5 to Axiom 12. RMK-10 doesn’t turn on or is seen by MFD. On second RMK-10 without using external power and stir not seen. First RMK-10 connected to external power and did not power up. What I’m I doing wrong?
Find all posts by this user
Quote this message in a reply
04-26-18, 03:14 PM (This post was last modified: 04-27-18 08:47 AM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] Axiom RMK-10
Welcome to the Raymarine Forum Larry,

When used with any product other than a gS-Series MFD, the RMK-9 and RMK-10 Remote Keypads must be powered from a switched 12VDC power circuit. While it sounds as though you may have had a problem with the first RMK-10, the second is clearly missing installation of power. Once properly installed, then RMK-10 must be paired to the MFD. Detailed instructions for doing so may be found within Chapter 4.9 Device pairing of the LightHouse 3.4 Advanced Operation Instructions.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication