[CA] [CA11] ES98 and ST600

[rcolesny]

I installed a ES98 MFD and Quantum radar to replace an old C80.
In order to interface with the legacy ST60 pilot, I connected a Seatalk1 to Seatalk-ng converter kit.
- After update of the software, the radome and MFD interfaced via WIFI =OK.
- Owner proceeded
sea trials for the pilot interface. The system controlled navigation to a defined way point =OK
- Owner could not get the system to follow a route of multiple points. I did not attend the procedure.

1. Is my installation scheme correct
2. I had no good access to the whole circuity. I did not follow the two legacy Seattle "circle segment/rectangular" plugs. I just connected both to the back of the ST60.
3. Is there a system parameter to amend?
4. Is there a sequence of commands rot follow?

Thank you.

By the way: I have to thank MarineMax for giving me the lead to https://www.tecnografic.com. This company made a new instrument panel which fits the style of the rest of the dashboard.

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum rcolesny,

Please note that Raymarine has not produced an autopilot having the name ST60. The photo which you have shown appears to be a ST6002+ autopilot control head. What model of autopilot course computer has been installed onboard the vessel? What version of software is installed within the eS-Series MFD? What version of software is installed within the SeaTalk to SeaTalkng Converter?