Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Transducer Clarification
09-27-18, 09:54 AM (This post was last modified: 09-27-18 10:26 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Transducer Clarification
I have purchased an i70 and will be replacing both separate speed and depth transducers.

I understand I will need the iTC-5 unit to work with i70, and am looking at the ST60/290 speed transducer and either the P19 or CPT-S as a depth.

Plan being when I upgrade the existing plotter I already have a transducer that will provide sonar readings to the plotter if going down the CPT-S route.

Would this set up work with just the i70 in the meantime?
Find all posts by this user
Quote this message in a reply
09-27-18, 10:26 AM (This post was last modified: 09-27-18 10:26 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Transducer Clarification
Welcome to the Raymarine Forum Tillysstar,

CPT-S, DownVision, RealVision, and CHIRP transducers cannot be interfaced directly to depth instruments, an iTC-5, or to a depth instrument pod. It is however possible for an instrument which is capable of reporting depth data to be interfaced to a MFD which has in turn been interfaced to a CPT-S, DownVision, RealVision, and CHIRP transducer. When so interfaced, the instrument may report depth determined by the MFD.
Find all posts by this user
Quote this message in a reply
09-27-18, 12:18 PM
Post: #3
RE: [CA11] Transducer Clarification
Thanks for the info Chuck,

I'll stick with the standard depth & speed transducers, with iTC-5 to convert signal for the i70
Find all posts by this user
Quote this message in a reply
09-27-18, 01:02 PM
Post: #4
RE: [CA11] Transducer Clarification
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)