[CA] [CA11] LifeTag works, but will not show on A98mfd chart

[jwashmon]

Just bought a new LifeTag system and did the recommended test and it works in chosen location, but it will not make a MOB waypoint on my A98 display. I have the A98 connected via Seatalk-ng to SeaTalkng converter to a seatalk 3-way junction block then to the LifeTag base station with alarm connected. Is there something I am missing, I can find no additional info on this issue. I am using navionics charts is that matters.

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum jwashmon,

Please note that Lifetag was retired quite a while ago and support is now quite limited. Please be aware that a SeaTalk to SeaTalkng (Socket) Adapter Adapter Cable cannot be used for this purpose. A SeaTalk to SeaTalkng Converter Kit must be used for this purpose. When using this kit, the SeaTalk bus should be powered via the SeaTalk to SeaTalkng Converter. Should one have properly installed the SeaTalk to SeaTalkng Converter, then it may be possible that the software level of the Converter or of the MFD may be preventing the MOB event from being passed to the MFD. Please produce and respond with the Diagnostic...html file from your system's Data Master MFD (i.e. add as an attachment to your response).