Raymarine forum / Raymarine Forums / Multifunction Displays v / [DG] [DG11] Power On Factory Reset

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Power On Factory Reset
07-22-19, 08:36 AM (This post was last modified: 07-25-19 10:07 AM by Derek - Raymarine - Moderator.)
Post: #1
[email protected] Offline
Junior Member
**
 		Posts: 21
Joined: May 2016
Reputation: 0
[DG11] Power On Factory Reset
Hello,
Is it ok to reload a previously saved setting backup following a Power On Factory Reset ? Or we should restart all config from scratch ? (Axiom 12)
Thanks,
David
Find all posts by this user
Quote this message in a reply
07-25-19, 10:36 AM
Post: #2
Derek - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,416
Joined: Nov 2017
Reputation: 9
RE: [DG11] Power On Factory Reset
Hi David,

Thank you for your enquiry.

Once you saved your settings , you can reload them back into the display once you have updated the software - note that it is a good idea to carry out a full factory reset after an update or full reset, the only time you will not be able to do this is if you update from Lighthouse 2 to Lighthouse 3.

regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication