Raymarine forum / Raymarine Forums / Networking / System Integration v / Raymarine Product LEN Matrix.

Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Raymarine Product LEN Matrix.
03-03-16, 08:44 AM (This post was last modified: 04-03-20 12:17 PM by Chuck - Raymarine - Moderator.)
Post: #1
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
Raymarine Product LEN Matrix.
Raymarine Product LEN Matrix.

When installing a SeaTalkng backbone, it is recommended that the power insertion spur for the backbone be located at the approximate mid-point of the backbone's LEN load. Additionally and while some autopilot ACU and course computers will support powering a backbone, it is considered to be a best installation practice to power a backbone from a dedicated switched 12VDC power circuit. Please see the Product Load Equivalency Numbers (LEN) Matrix for legacy products and several current products attached to this discussion. The LEN values for currently produced Raymarine products may be found within the Specifications section of each product's respective installation guide. To view more information on SeaTalkng networking, click here.

RAYFAQ#


Attached File(s)
.pdf  Lenmatrix_03_03_2015.pdf (Size: 37.32 KB / Downloads: 4303)
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication