RealVision 3Dâ„¢ sonar
|
02-16-17, 12:34 PM
Post: #1
|
|||
|
|||
RealVision 3Dâ„¢ sonar
Will RealVision 3Dâ„¢ sonar be compatible with eS series?
Can RealVision 3Dâ„¢ sonar be used on a sailboat? Will RealVision 3Dâ„¢ sonar allow a sailboat to use the software to see in front of the boat? |
|||
02-16-17, 02:20 PM
Post: #2
|
|||
|
|||
RE: RealVision 3Dâ„¢ sonar
Lazybones,
Q1. Will RealVision 3Dâ„¢ sonar be compatible with eS series? A1. Please click here to view a FAQ addressing this subject. Q2. Can RealVision 3Dâ„¢ sonar be used on a sailboat? A2. RealVision 3Dâ„¢ sonar is primarily intended for use with power driven vessels. However, as Raymarine will be offering a RealVision 3Dâ„¢ Sonar Thru-hull Transducer, it would be technically possible to outfit a sailboat with RealVision3D Sonar. In such installations, the transducer would likely need to be installed forward of the keel. Q3. Will RealVision 3Dâ„¢ sonar allow a sailboat to use the software to see in front of the boat? A3. RealVision 3Dâ„¢ Sonar is not forward looking sonar. While capable of producing a 3D image, it is essentially historical in nature (i.e. sonar data is captured as the bottom and water column pass beneath the transducer). |
|||
02-16-17, 05:33 PM
Post: #3
|
|||
|
|||
RE: RealVision 3Dâ„¢ sonar
I see that there are new All-In-One transducers coming out along with the Axiom MFD's. Will it be possible to use the combination of a CPT 100 transducer connected to an A series MFD with CHIRP DownVision (aX8 models) and a networked CP 200 / CPT 200 to use the RealVision 3D sonar?
I understand there could be an issue with aligning the resulting imaging created by the two independent transducers, but I would think it would be possible to achieve through some sort of calibration process. 1977 SeaRay SRV 240 SDB Raymarine a78 / CPT100, EV-100 Power, CP200 / CPT 200, Ray60 |
|||
02-16-17, 06:03 PM
(This post was last modified: 02-16-17 06:04 PM by Chuck - Raymarine - Moderator.)
Post: #4
|
|||
|
|||
RE: RealVision 3Dâ„¢ sonar
Welcome to the Raymarine Forum scoffer,
Q: Will it be possible to use the combination of a CPT 100 transducer connected to an A series MFD with CHIRP DownVision (aX8 models) and a networked CP 200 / CPT 200 to use the RealVision 3D sonar? A: No. Unlike past DownVision and SideVision transducer designs, the RealVision 3Dâ„¢ feature a built-in attitude and heading reference sensor to compensate for transducer misalignment with the fore-aft axis of the boats, roll, pitch, and yaw. This additional sensor within the transducer is in large part responsible for the high quality of the RealVision 3Dâ„¢ Sonar imaging. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)