Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] i70s and p70s
04-14-18, 03:20 PM (This post was last modified: 04-16-18 12:37 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] i70s and p70s
What is the simplest way to connect a p70s autopilot control head and two i70s multifunction instruments within a guard mounted instrument pod to minimize the amount of cables/connectors within the pod?
Find all posts by this user
Quote this message in a reply
04-16-18, 12:40 PM (This post was last modified: 04-16-18 12:41 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] i70s and p70s
Welcome to the Raymarine Forum sailM27,

As indicated within the FAQ found here addressing this subject, it is recommended that one end of the backbone terminate within instrument pod (typically located above the MFD/chartplotter pod). Please review the referenced FAQ for further details on this subject.
Find all posts by this user
Quote this message in a reply
04-16-18, 02:38 PM (This post was last modified: 04-16-18 03:46 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA] i70s and p70s
Elbow for spur cable. Is there an elbow available for straight spur cables? I want a spur cable with an elbow at one end to connect to i70s and straight at other end to connect to 5 way connector inside instrument pod. The elbow spur connector has elbows at each end.
Find all posts by this user
Quote this message in a reply
04-16-18, 03:50 PM
Post: #4
RE: [CA] i70s and p70s
sailM27,

Raymarine SeaTalkng / NMEA 2000 networking components may be found here. There, you will find the A06042 Spur cable having right plugs on each end of the spur cable. Raymarine does not make a spur cable having a right angle plug on one end and a straight plug on the other end.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)