Raymarine forum / Raymarine Forums / Multifunction Displays v / Cannot enable LightHouse 3 Autopilot Controls feature with legacy autopilot

Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cannot enable LightHouse 3 Autopilot Controls feature with legacy autopilot
05-30-18, 01:55 PM (This post was last modified: 06-01-18 02:14 PM by Chuck - Raymarine - Moderator.)
Post: #1
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
Cannot enable LightHouse 3 Autopilot Controls feature with legacy autopilot
Cannot enable LightHouse 3 Autopilot Controls feature with legacy autopilot

The Autopilot Controls feature of LightHouse 3 software is restricted to systems featuring Evolution autopilots. While this feature is not supported in systems featuring compatible legacy Raymarine autopilots or compatible third party autopilots, MFDs running LightHouse 3 software are indeed capable of supplying navigational and steering data to compatible autopilots to support use of the autopilot's Track mode feature. The MFD will initiate communications of such data when navigation (Go To Waypoint / Cursor Position or Follow Route) has been commanded through the LightHouse 3 software. The autopilot may then be commanded into Track mode via the autopilot's control head.


RAYFAQ#
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication