Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] C120 video has fast horizontal shifting
05-29-19, 11:22 AM (This post was last modified: 05-30-19 01:00 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] C120 video has fast horizontal shifting
My C120 plotter has worked perfectly for many years. On my last cruise, it worked great for about an hour then everything started shifting, very quickly, horizontally a very small amount. Initially, I was able to still read the text. After roughly an other hour or so, the shifting moved the text more and more. Roughly an hour later the shifting was so bad, the whole screen was unreadable.

I had the diesel on, so turned it off to run strictly from fully charged batteries (thinking there could be some alternating current noise). I turned everything possible off (thinking some RF caused this). Even after turning the C 120 off then back on, the shifting came back

Is there anything else I can try (it can be reproduced after roughly 30 minutes)?

Can a graphics board be swapped inside the unit? Does RM have any of these in stock, what is the cost?

Find all posts by this user
Quote this message in a reply
05-30-19, 01:06 PM
Post: #2
RE: [CA11] C120 video has fast horizontal shifting
Welcome to the Raymarine Forum Norm,

Unfortunately, it appears that the MFD has suffered a failure within its internal circuitry necessitating repair or replacement of the MFD. While Raymarine's Product Repair Center can no longer service these MFDs, Seawire Marine ((305) 489-1600) may be able to assist you with repairs to this legacy MFD.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)