rudder limit, set uup issue

[Chuck - Raymarine - Moderator]

Eric,

Did you verify that the alignment tab (located on the opposite side of the rotary rudder reference transducer's arm) was aligned with the alignment tab on the transducer's base when the rudder was centered? If not, then the rudder reference transducer's installation will need to be adjusted accordingly. Should you have done so, and the problem persists, then it would be recommended that rudder reference transducer which had initially been installed for use with the original autopilot be replaced with that provided with the ACU-200. Should the problem persist thereafter, then it would indicate a problem with the ACU-200 necessitating that it be sent to Raymarine’s Product Repair Center to be bench checked / serviced.