ACU 200 EV-1 Autopilot Install 39' Silverton aft cabin MY

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Mark,

Q1. The ACU, EV-1 sensor and rudder sensor will all be mounted in close proximity to each other behind cabinetry in the aft cabin. The hydraulic pump will be located in the engine room. Should I be concerned that there will be RF interference between the ACU and EV-1?

A1. Please click here to view a FAQ addressing this subject. Evolution ACU's would indeed be considered to be among the electronic devices which a magnetic north seeking device (ex. EV-1 / EV-2 Sensor Core, etc.) should not be installed within close proximity to.


Q2. The control head at the helm will require 50+ feet of backbone cable. I'm planning to use a PN A06037 20m extension cable. Any problem with that?
A2. No. That said, it is considered to be a best practice to power the backbone via a 12V feed to a spur socket located at the approximate mid-point of the backbone's LEN load rather than rely upon the ACU-200 to power the backbone (particularly larger backbones)

Q3. There is no practicable way to mount the rudder sensor directly parallel to either of the rudder arms due to space restrictions. The rudder arms point aft. We are planning on making a "U" shaped bracket that will mount the rudder sensor inverted and pointed forward and attach it to the tie bar. We intend to fabricate this installation so that the sensor will mimic the 6" center to center distance of the rudder arms.
A3. Your solution appear to be satisfactory.