The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / C80 magnetic variation

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
C80 magnetic variation
05-06-17, 04:49 PM
Post: #1
Brian Rutter Offline
Junior Member
**
 		Posts: 4
Joined: Apr 2016
Reputation: 0
C80 magnetic variation
Hi,
I have a C80 MFD running v5.16 software and networked to ST60 wind, speed, depth, a i70, ST6000 Autohelm and 120 GPS sensor.
The C80 is set to display magnetic bearings. Each time the MFD is powered on the magnetic variation is set to 2 degrees W which is not correct for my area (Toronto). I can manually set it back to 11W and it is fine until it is powered down. When powered back up it resets to 2W. It does not matter if the MFD is set to manual or automatic variation, same issue. The autopilot is set to 43 degrees latitude for its variation calculation and the ST6000 magnetic display is correct.
The result is the MFD is always displaying the incorrect magnetic bearings unless the variation is manually changed at every power up.
Any suggestions what could be the issue?
Thanks,
Brian
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
C80 magnetic variation - Brian Rutter - 05-06-17 04:49 PM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication