Seatalk1 to Seatalkng

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum David,

Q1: Will this converter allow bi directional data from the seatalk 1 to the seatalk ng? My concern is that all of the data from the S1G be available for the ng system data from the flux gate compass and the rudder reference.
A1: Yes, communications via a SeaTalk to SeaTalkng Converter is designed to be bidirectional. However, SeaTalk only support transmission of heading data a 1Hz. Should it be desired to provide the MFD with 5Hz heading data updates, then it would be recommended that the S1G's NMEA 0183 output port be interfaced to the MFD's NMEA 0183 input port.

Q2. Can I daisy chain the St6o wind directly to the I70 and receive the wind date via sealtalk ng, if so do you set the St60 as a master or a repeater?
A2. No. The i70 MFID cannot simultaneously support SeaTalk and SeaTalkng communications. The ST60 instrument display should be interfaced to the SeaTalk bus along with the S1G and its autopilot control head. The present source of power to the SeaTalk bus should be disconnected (this may be the red terminal of the S1G's SeaTalk port and if so, the red lead of the SeaTalk cable should be disconnected from that terminal). The SeaTalk bus will be powered by the SeaTalkng backbone via the SeaTalk to SeaTalkng Converter.