The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Fishfinders v / Problem with CP370 and E140W

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem with CP370 and E140W
06-12-17, 01:15 PM
Post: #1
cwhite6 Offline
Junior Member
**
 		Posts: 2
Joined: Oct 2016
Reputation: 0
Problem with CP370 and E140W
I have a CP370 and E140W on my boat. I have both a P66 and M260 transducers, only connected one at a time. With either one of the transducers connected, sometimes the MFD will just lose the transducer readings. It will read insanely deep or shallow for where I am or it will just not read anything. It will work fine for a few hours and then just stop. It doesn't matter which transducer is connected. Any ideas for things to look at? The CP370 is less than a year old and has a dedicated power connection to a fuse block. The voltage at the CP370 reads above 13 volts.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Problem with CP370 and E140W - cwhite6 - 06-12-17 01:15 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication