Heading COG Mismatch (E125/ACU400/EV-1/P70/I70)

[lwitty]

Thanks Chuck, I will perform the recommended actions this afternoon.

Two more questions since I have fwd'd the network diagram to you:
1) is the LEN setup correct? Given the power comes into the 5-way, not sure if that is really the "middle" of the network or not.
2) Depth has been acting up and really noticed it since the install of the ACU400 (not sure if related or not...). I will verify that the SeaTalk power is off on the ACU400 but I have also read that removing the shield from the depth transducer to reduce noise has been recommended. If SeaTalk ACU power is off, is good next step to remove the shield (transducers where installed with the old ST instruments and individual depth and speed/temp - not a DST800).