Raymarine forum / Raymarine Forums / Multifunction Displays v / ST60 Depth Issue

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST60 Depth Issue
06-27-17, 08:49 AM (This post was last modified: 06-27-17 08:53 AM by Chuck - Raymarine - Moderator.)
Post: #4
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: ST60 Depth Issue
Neil,

Thanks for the clarification concerning the depth of the water and the offset. The offset must be applied in the instrument, not within the MFD's settings. Can you further explain your comment about "piggy back"? Are you referring to how the MFD is being powered or how the MFD has been interfaced to the SeaTalk bus? Also, when interfacing the MFD to a SeaTalk bus, it is recommended that the red lead of the SeaTalk cable connecting the MFD to the SeaTalk bus be severed and that the severed red leads then be insulated to prevent shorting.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST60 Depth Issue - NeilB - 06-25-17, 04:28 PM
RE: ST60 Depth Issue - NeilB - 06-27-17, 08:20 AM
RE: ST60 Depth Issue - Chuck - Raymarine - Moderator - 06-27-17 08:49 AM
RE: ST60 Depth Issue - NeilB - 06-27-17, 10:12 AM
RE: ST60 Depth Issue - NeilB - 06-27-17, 12:26 PM
RE: ST60 Depth Issue - NeilB - 06-27-17, 03:13 PM
RE: ST60 Depth Issue - NeilB - 06-27-17, 07:30 PM
RE: ST60 Depth Issue - NeilB - 07-14-17, 04:43 PM
RE: ST60 Depth Issue - NeilB - 07-17-17, 07:54 PM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication