Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
updated, missing Raystar 130 data
03-31-16, 09:16 AM
Post: #2
RE: updated, missing Raystar 130 data
Welcome to the Raymarine Technical Forum Oregoncme,

Please note that no other reports of this issue have been received and that the RS130s within our systems, as well as that on my own boat (updated with v16.47 software over the weekend (ACU and RS130 software updated as well)) have been functioning properly following the update.

It is recommended that your ensure that:
- the SeaTalkng backbone has been powered ON ... MFD's do not supply power to the SeaTalkng backbone. If uncertain which circuit is supplying power to the SeaTalkng backbone, then all of the marine electronics circuits should be powered ON.
- verify that the Data Master MFD is communicating with the SeaTalkng backbone and the RS130 ... use the command sequence HOME->SET-UP->MAINTENANCE->DIAGNOSTICS->SELECT DEVICE to display the list of all devices which the MFD has detected as being interfaced to the MFD via Ethernet (SeaTalkhs) and SeaTalkng (STng).
- Should the RS130 be listed within the Devices List, then the MFD's Data Sources feature (HOME->SET-UP->SYSTEM SETTINGS->DATA SOURCES) should be utilized to manually select the RS130 to be the system's GPS sensor.
- Should the problem persist thereafter, then please click here to view a FAQ addressing how to troubleshoot a RS130 GPS sensor.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: updated, missing Raystar 130 data - Chuck - Raymarine - Moderator - 03-31-16 09:16 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)