updated, missing Raystar 130 data

[Oregoncme]

Chuck, I finally figured out what the problem was yesterday after an hour and a half of realizing the GPS was not selectable in Auto (GPS selection on the plotter) rather, it was in manual and would not accept it. Strange. The fix was to turn off the Autopilot completely. Then go into e165 and then select the Raystar 130. Some reason, it was not allowing the GPS data to be selected as a viable Auto GPS source. But again, it WAS seen on the data selection. Anyway, after it was seen as an Auto choice, it was selected and perfect since. Repowered up the AP, all was well.

All I can say, everything was fine after the updates. But I was initiating a turn via the P70r root knob (quick twist), the plotter did a re-spring (turned off and it went into endless restart loop for 5-7 minutes. The ONLY WAY to clear it was a master flob reset. The issue began immediately after that.

You were spot on referring to the GPS selection. Strange the AP was causing the GPS data to be locked. Maybe next time I will restart BOTH DEVICES after performing the wifi updates.