cam220Ip in accessible

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Oregoncme,

Q. Do i need to attempt to access the camera THROUGH the network switch port or at the actual camera ethernet plug?
A. The IP camera's Ethernet cable should be plugged directly into the PC. Alternatively, the IP camera may be disconnected from the HS5 RayNet Network Switch and then connected directly to the PC via an assembly constructed from an A80162 RayNet (M) Pins to RayNet (M) Pins Cable Joiner and an appropriate length of RayNet (F) to RJ45 (M) Cable.

The supplied IPScan Utility may then be used to determine the IP address of the IP camera. To access the IP camera's web page, configure the PC's IP address within the same address range as that of the IP camera ... be certain not to configure the PC with the same IP address as assigned to the IP camera (I generally recommend using an IP address which is either 1 increment greater than or less than the IP camera's IP address). Assign the PC's subnet mask to 255.255.255.0. Finally, enter the camera's IP address into the address field of an Internet Browser (Google Chrome recommended).