Raymarine forum / Raymarine Forums / Multifunction Displays v / eS98 and eS127 MFD's - Interrupt Problems?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
eS98 and eS127 MFD's - Interrupt Problems?
08-16-17, 01:13 PM (This post was last modified: 08-16-17 02:11 PM by Chuck - Raymarine - Moderator.)
Post: #3
mikeyor Offline
Junior Member
**
 		Posts: 9
Joined: Aug 2017
Reputation: 0
RE: eS98 and eS127 MFD's - Interrupt Problems?
Chuck, many thanks for the welcome and the excellent reply addressing the start up issues I encountered. I have read through the FAQ you referred me to and reviewed your reply comments. All makes sense. I think I must have been switching on the breakers for vhf/ais, autopilot/instruments and radar immediately after pressing the mfd power buttons and thus not letting the mfd's fully initialize. Henceforth I will leave the mfd power buttons in the on state and use the dedicated circuit breaker to turn the two mfd's on and off. I tested this aboard my boat today and I am delighted to say that everything was working as it should.

Thank you again

Mike
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: eS98 and eS127 MFD's - Interrupt Problems? - mikeyor - 08-16-17 01:13 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication