Axiom 7 RV Software update 3.1.96 issue

[jmcjmc817]

I have an Axiom 7 RV that was running 3.0.60. I have an older BV744 transducer plugged directly into the Axiom using an adapter cable. I had no problems configuring it and getting it to work correctly. When I up dated the software to 3.1.96, I am having problems configuring the transducer. In the Sonar settings --> transducer page, it says "NONE" so I cannot set the Below Keel/Below Waterline/Below Transducer setting. I've tried selecting different transducer on initial set up, but that page always says "NONE" I am able to see the Sonar Display and depth, so I know it is recognizing the Transducer. I re-installed the older software 3.0.60 and the transducer page is displaying the info so I can configure the depth. So at this point in time, I'm stuck with the 3.0.60 version. Any suggestions? Thanks in advance.