The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] Fluid Level Sensors - Maretron or Garmin

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Fluid Level Sensors - Maretron or Garmin
09-07-17, 11:22 AM (This post was last modified: 05-28-19 08:29 AM by Chuck - Raymarine - Moderator.)
Post: #1
headshothills Offline
Junior Member
**
 		Posts: 1
Joined: Feb 2017
Reputation: 0
[CA11] Fluid Level Sensors - Maretron or Garmin
Question for those of you who have added the Maretron TLA100 or Garmin GFL 10..

How did you configure them?? According to each manufacturer, you must use one of their compatible devices to configure the Fluid Level Sensors...

I have not seen 1 post that says a Raymarine device, specifically a MDF, can configure either of these 2, so what are you guys doing to configure them?

Im looking to add these on top of my analog gauges to be able to display the data through the NMEA2000 network to my ES97.

Some of the configuration points that I see as important for configuring are...

Tank Type
Tank Number
Operating Mode
Tank Capacity
Resistive Sender
Calibrating

I dont have a Maretron or a Garmin in my System, just a ES97 and i70s... So what is everyone doing?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Fluid Level Sensors - Maretron or Garmin - headshothills - 09-07-17 11:22 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication