Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] E120 data feed, move from Seatalk 1 to Seatalk ng

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] E120 data feed, move from Seatalk 1 to Seatalk ng
11-01-17, 04:25 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: E120 data feed, move from Seatalk 1 to Seatalk ng
Welcome back to the Raymarine Forum Lothar,

Q1. Now with an ng bus, I believe I use an adapter to feed all the data from the ng bus to the Seatalk 2 input on the primary E120 and MUST disconnect the old Seatalk 1 bus, true?
A1. Correct

Q2. Is there any system configuration settings to change in the E120 to make it look at the Seatalk 2 input?
A2. Negative. The MFD will automatically pick up data via its SeaTalk2 port ... ensure that the MFD has v5.69 software installed within its memory.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: E120 data feed, move from Seatalk 1 to Seatalk ng - Chuck - Raymarine - Moderator - 11-01-17 04:25 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication