The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
M232 Installation Location (TG)
11-28-17, 09:31 AM (This post was last modified: 11-29-17 06:06 PM by Tom - Raymarine - Moderator.)
Post: #1
M232 Installation Location (TG)
I am considering adding the M232 to my system. I have a question about the mounting location. My boat has a hardtop but limited access to mounting from underneath. I have attached a photo showing the hardtop where you will notice a raised area. It is under this area that there is access for fixing and cables. However, that same area is now occupied by a 48" open array and a KVH Sat dome. The area in front of the open array will not allow access for fixing and cables would be near impossible to make up.

I am wondering what your thoughts would be about mounting the M232 on the bow rail in place of the Spot Light? I realize that I would need longer cable runs to accomplish this and it of course will not be the highest point or looking reward without manuvering the boat. It would also require using a handheld spot light if needed.

Thoughts related to this solution or perhaps I dont have enough real estate and forget the whole idea!

Thanks in advance
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
M232 Installation Location (TG) - mpo881 - 11-28-17 09:31 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)