Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST290 Display (E22056)
12-05-17, 03:39 PM (This post was last modified: 12-06-17 07:24 AM by Derek - Raymarine - Moderator.)
Post: #11
RE: ST290 Display (E22056)
Got it. I think I have led you a bit astray of my goals, so please let me back up for a moment. I need to replace my C80 MFD because the NMEA0183 port is damaged (confirmed by wraparound test) and I am not able to get position data to my VHF for DSC utilization. That is a safety issue that I need to address. The eS97 has a nice drop-in size for my existing helm space and I am trying to upgrade without having to re-fiberglass and gel coat the entire helm.

The ST290 is causing problems because it has a huge cutout. None of the replacements (i50/i70) are large enough to fill that [censored]. I only use my ST290 for speed and sea temp data--that is it. So I really don't need to replace it. What if I keep that as an isolated SeaTalk2 system and upgrade in two steps as shown in my diagrams?

Step 1 is adding the eS97 MFD and the STng backbone.

Step 2 is replacing my existing autopilot with an Evolution system.

Q: With the eS97 having a built-in GPS receiver, should I keep my existing RS130 GPS receiver so I have two GPS sources? Or get rid of it?

Thanks

Dave


Attached File(s)
.pdf  Step 1.pdf (Size: 125.02 KB / Downloads: 371)
.pdf  Step 2.pdf (Size: 134.49 KB / Downloads: 397)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST290 Display (E22056) - ddfour1 - 11-30-17, 11:28 AM
RE: ST290 Display (E22056) - ddfour1 - 12-01-17, 02:14 PM
RE: ST290 Display (E22056) - ddfour1 - 12-04-17, 11:02 AM
RE: ST290 Display (E22056) - ddfour1 - 12-05-17, 09:52 AM
RE: ST290 Display (E22056) - ddfour1 - 12-05-17 03:39 PM
RE: ST290 Display (E22056) - ddfour1 - 12-06-17, 10:55 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)