Raymarine forum / Raymarine Forums / Thermal Cameras v / M232 Installation Location (TG)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
M232 Installation Location (TG)
12-06-17, 01:26 AM
Post: #4
Tom - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,067
Joined: Nov 2017
Reputation: 7
RE: M232 Installation Location (TG)
Hi mpo,

Yes, in that case, mounting on the bow rail seems like the best approach. I don't see a problem with cable runs as long as you use a suitable gauge of supply cable for the length of the run. Vibration I'm not in a position to comment on specifically relating to your boat - if you had a lot of vibration at that point, you could perhaps see some blurring of the image whilst under way, but I think it's unlikely.

Regards,
Tom
Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: M232 Installation Location (TG) - Tom - Raymarine - Moderator - 12-06-17 01:26 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication