Threaded Mode | Linear Mode

rlschmidt

I checked what I called a termination on my diagram for the P70R and it is black, so I guess it is correct.
I have downloaded the software and looked at the update procedure on your website, and have a couple of questions.
1. The procedure indicates that the update files should not be stored in a folder. Is this just because they would not be found during update? In other words, if I copy the needed files from a folder to the root of the flash drive would the duplicates in the sub-folder interfere with the update procedure in any way. I am asking this because the flash drive is an appropriate place to keep the update files for all of the devices so if they can be stored in sub-folders without interfering with the update, I can bring the desired files into the root directory of the drive as needed.
2. Does the autorunc.dob file in the folder only deal with the files in that folder, or is it more generic?

I tried updating the CCU from the C90W, and the device could not be discovered so the upgrade failed. Would it make sense at this point to run temporary cables to the C90W to see if there is a cable issue? I would like to eliminate cable failures before saying the ACU is not working. Would the control head recognize the ACU if the display unit is disconnected (It dosn't)? I did also try a system reset from the P70r and that did not make a difference. I guess what I am looking for is what is the minimum system that should work?

Thanks
Bob Schmidt