Threaded Mode | Linear Mode

OldPete

After 2 years of owning the boat, the ONLY thing that doesn't work is the AP. It is an older S1 with ST8002 and a ST6002 at the upper station.

I just repaired the rudder indicator -- and now get nice even resolution on the bar indicator.

I am trying to determine what the latest version of firmware is for the S1 and what changes were made from update to update to see if this is something I should do. I *think* (going by memory) that the current is v.3.04... I know the ST8002 is @ v5.00.
The diagnostics show that there are approximately 50 hours on the AP. (Assuming that is what it means when I continue to scroll through the ST8002 version information).

I have not been out to seatrial calibrate since repairing the rudder bar, so I am not certain upgrading the firmware for the S1 is prudent or needed.

There is no Gyro on the S1.

The pump is working correctly. The link between the E120 and the S1 is also working. (Shows when in auto and when in standby).

Prior to repairing the rudder indicator I was able to successfully complete the compass calibration (2 full wide turns via Seatrial mode). I was unable to complete the zig-zag portion of the test... likely due to the malfunctioning rudder indicator.

The balance of the system is a E120 with DSM300 and SeaTalkHS, and a 10KW Open Array 4' Radar.

Application:
2006 WorldCat 320EC
Twin Suzuki 300AP (2017)

Please let me know if there are any other pertinent questions.