[CA] axiom screen freeze

[Chuck - Raymarine - Moderator]

gmckenzie,

Please excuse this late response to your post. On the advise of our engineering team, it had been advised that further troubleshooting of this problem be delayed until the LH 3.3 had been released, as the LH 3.3 software update includes corrections targeted at addressing symptoms such as you have described. That said, LightHouse v3.3.170 was released yesterday. Accordingly, it is recommended that your system's data be backed up, that the LightHouse v3.3.170 software update be downloaded and installed within the MFD's within your system. After doing so, it is recommended that Error Logs erased (HOME->SETTINGS->NETWORK->DIAGNOSTICS->ERASE LOGS), a Factory Reset be commanded (HOME->SETTINGS->THIS DISPLAY->FACTORY RESET), that your system's data then be imported back into the system, and that the system then be tested again.

Should the problem persist thereafter, then please respond with the following and a new problem report will be logged:
- photo of the MFD's screen when the problem occurs
- description of the problem to include information specifying whether the MFD is responding to any screen / button commands
- system diagram identifying each of the products within your marine electronics system and how they have been interface to one another
- Logs (HOME->SETTINGS->NETWORK->DIAGNOSTICS->SAVE LOGS)
- System Logs (HOME->SETTINGS->NETWORK->DIAGNOSTICS->SAVE SYSTEM LOGS)