CP100 No Network Error

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum dsteiger,

We're sorry to learn of the reported issue with your system.

Note: transducer selection is neither necessary nor supported with a CP100, as the CP100 is compatible with a set of transducers having identical performance. One need simply use the command sequence MENU->CHANNEL->CP100->SONAR/DOWNVISION to select the type of fishfinder imaging support by the CP100 to be viewed.

The CP100's Network (Ethernet) socket should be mated to one of the c97 MFD's Network sockets via an appropriate length of RayNet (F) to RayNet (F) Cable. Alternatively, both of these items may have been interfaced to a HS5 RayNet Network Switch via appropriate lengths of RayNet (F) to RayNet (F) Cable. Should a HS5 RayNet Network Switch have been installed onboard, then please verify that has been connected to a 12 or 24V power circuit which has been energized. If so, then it it recommended that the RayNet cables be inspected to ensure that the have not been damaged, modified, or have been subjected to a bend radius of less than 3". Subjecting a RayNet cable to a bend of lower radius may permanently damage the RayNet cable(s).

Should the equipment have been installed in the manner specified above, then it would be recommended that the MFD's Network sockets be both tested with another compatible device (ex. radome or open array pedestal, SR150, another a/c/e/eS/gS-Series MFD, etc. should one be available. Should the MFD's Network sockets both be found to be operational, then the CP100 should be replaced by the dealer (if purchased less than 30 day prior) or to Raymarine’s Product Repair Center to be bench tested/serviced.